Users Guide

set next-hop track
Tracks the next-hop IPv4 or IPv6 address object.
Syntax
set {ip | ipv6} vrf [vrf-name] next-hop address track track-id
Parameters
● address—Enter an IPv4 or IPv6 address.
● vrf vrf-name — Enter the keyword then the name of the VRF to track the next-hop reachable
through that VRF.
● track-id—(Optional) Enter the track ID of the PBR object.
Defaults Not configured
Command Mode ROUTE-MAP
Usage
Information
You must configure next-hop IP address tracking and PBR next-hop with the same VRF instance. For
next-hop reachability in the same VRF instance, you must configure both PBR per VRF and object
tracking. Missing either the next-hop IP address tracking or PBR next-hop configuration in a VRF instance
results in an erroneous configuration. However, the system does not display an error message indicating
problems in the configuration.
Example
OS10(conf-route-map)# set ip next-hop 10.10.10.10 track-id 12
*Set the track ID configured to the route-map.
OS10(conf-route-map)# set ip vrf red next-hop 1.1.1.1 track-id 200
*Sets the track ID configured to track the next-hop reachable through
the VRF specified.
Supported
Releases
10.3.0E or later
show policy
Displays policy information.
Syntax
show {ip | ipv6} policy [map-name]
Parameters map-name — (Optional) Enter the name of a configured route map. A maximum of 140 characters.
Defaults None
Command Mode EXEC
Usage
Information
None
Example
OS10# show ip policy map-name
Supported
Releases
10.3.0E or later
show route-map pbr-statistics
Displays the current PBR statistics.
Syntax
show route-map [map-name] pbr-statistics
Parameters map-name — (Optional) Enter the name of a configured route map. A maximum of 140 characters.
Defaults None
Command Mode EXEC
Usage
Information
None
812 Layer 3