API Guide

If the Fabric Switching Engine is in Full Switch mode, configure the switch using the CLI. You must
manually configure the unit ID of the Fabric Expander, for more information see Virtual ports. The unit ID is
also called the virtual slot ID.
Example
OS10# show discovered-expanders
Service- Model Type Chassis- Chassis-slot Port-group
Virtual-
tag service-tag Slot-
Id
--------------------------------------------------------------------------
403RPK2 MX7116n Fabric 1 SKY003Q A2 1/1/2 71
Expander Module
Supported
Releases
10.4.0E(R3S) or later
show interface
Displays interface information.
Syntax
show interface [type]
Parameters interface type Enter the interface type:
phy-eth node/slot/port[:subport] Display information about physical ports connected to
the interface.
status Display interface status.
ethernet node/slot/port[:subport] Display Ethernet interface information.
loopback id Display Loopback IDs, from 0 to 16383.
mgmt node/slot/port Display Management interface information.
null Display null interface information.
port-channel id-number Display port channel interface IDs, from 1 to 128.
vlan vlan-id Display the VLAN interface number, from 1 to 4093.
Default Not configured
Command Mode EXEC
Usage
Information
Use the do show interface command to view interface information from other command modes.
Example
OS10# show interface
Ethernet 1/1/2 is up, line protocol is up
Hardware is Dell EMC Eth, address is 00:0c:29:54:c8:57
Current address is 00:0c:29:54:c8:57
Pluggable media present, QSFP+ type is QSFP+ 40GBASE CR 1.0M
Wavelength is 64
Receive power reading is 0.0
Interface index is 17305094
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Enabled
Link local IPv6 address: fe80::20c:29ff:fe54:c857/64
Global IPv6 address: 2::1/64
MTU 1532 bytes, IP MTU 1500 bytes
LineSpeed 40G, Auto-Negotiation on
FEC is auto, Current FEC is off
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 00:40:14
Queuing strategy: fifo
Input statistics:
0 packets, 0 octets
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
Interfaces 297