Reference Guide

Example
OS10(conf-if-eth1/1/3)# lldp receive
Supported Releases 10.2.0E or later
lldp reinit
Congures the delay time (in seconds) for LLDP to initialize on any interface.
Syntax
lldp reinit seconds
Parameters seconds — Enter the delay timer value in seconds (1 to 10).
Default 2 seconds
Command Mode CONFIGURATION
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# lldp reinit 5
Supported Releases 10.2.0E or later
lldp timer
Congures the rate (in seconds) at which LLDP packets send to the peers.
Syntax
lldp timer seconds
Parameters seconds — Enter the LLDP timer rate in seconds (5 to 254).
Default 30 seconds
Command Mode CONFIGURATION
Usage Information The no version of this command sets the LLDP timer back to its default value.
Example
OS10(config)# lldp timer 25
Supported Releases 10.2.0E or later
lldp tlv-select basic-tlv
Enables or disables TLV attributes to transmit and receive LLDP packets.
Syntax
lldp tlv-select basic-tlv {port-description | system-name | system-description
| system-capabilities | management-address}
Parameters
• port-description — Enable or disable the port description TLV.
• system-name — Enable or disable the system TLV.
• system-description — Enable or disable the system description TLV.
• system-capabilities — Enable or disable the system capabilities TLV.
• management-address — Enable or disable the management address TLV.
Default Enabled
156 Layer 2