Reference Guide

Parameters string — Enter a description of the monitoring session (up to 255 characters).
Default Not congured
Command Mode MONITOR-SESSION
Usage Information The no version of this command removes the description text.
Example
OS10(conf-mon-local-1)# description remote
OS10(conf-mon-rspan-source-5)# description "RSPAN Sesssion"
Supported Releases 10.2.0E or later
destination (Port Monitoring)
Sets the destination where monitored trac is sent to. The monitoring session can be local or RPM.
Syntax
destination {interface interface-type | remote-vlan vlan-id}
Parameters interface-type — Enter the interface type for a local monitoring session.
• ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the destination.
• port-channel id-number — Enter a port-channel number as the destination (1 to 128).
• vlan vlan-id —Enter a VLAN ID as the destination (1 to 4094).
remote-vlan vlan-id—Enter a remote VLAN ID as the destination for RPM monitoring session (1 to 4093).
Default Not congured
Command Mode MONITOR-SESSION
Usage Information The no version of this command resets the value to the default.
Example
OS10(conf-mon-local-10)# destination interface port-channel 10
OS10(conf-mon-rspan-source-3)# destination remote-vlan 20
Supported Releases 10.2.0E or later
ow-based
Enables ow-based monitoring. The monitoring session can be one of the following: local, RPM.
Syntax
flow-based enable
Parameters None
Default Disabled
Command Mode MONITOR-SESSION
Usage Information The no version of this command disables the ow-based monitoring.
Example
OS10(conf-mon-local-1)# flow-based enable
OS10(conf-mon-rspan-source-2)# flow-based enable
Supported Releases 10.2.0E or later
Layer 2 219