Reference Guide

Parameters
• active — Reset the running partition as the next boot partition.
• standby — Set the standby partition as the next boot partition.
Default Not congured
Command Mode EXEC
Usage Information Use this command to congure the location of the OS10 image used to reload the software at boot time. Use the
show boot command to view the congured next boot image. This command is applied immediately.
Example
OS10# boot system standby
Supported Releases 10.2.0E or later
commit
Commits changes in the candidate conguration to the running conguration.
Syntax
commit
Parameters None
Default Not congured
Command Mode EXEC
Usage Information Use this command to save changes to the running conguration. Use the do commit command to save changes
in CONFIGURATION mode.
Example
OS10# commit
Example
(conguration)
OS10(config)# do commit
Supported Releases 10.2.0E or later
congure
Enters CONFIGURATION mode from EXEC mode.
Syntax
configure {terminal}
Parameters terminal — Enters CONFIGURATION mode from EXEC mode.
Default Not congured
Command Mode EXEC
Usage Information Enter conf t for auto-completion.
Example
OS10# configure terminal
OS10(config)#
Supported Releases 10.2.0E or later
Getting Started 43