Reference Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4148F-ON/S4148T-ON/S4148FE-ON

441

442

443

444

445

446

447

448

449

450

• fragment — (Optional) Use ACLs to control packet fragments.

• eq — (Optional) Deny packets which are equal to.

• ack — (Optional) Set the bit as acknowledgment.

• fin — (Optional) Set the bit as nish—no more data from sender.

• psh — (Optional) Set the bit as push.

• rst — (Optional) Set the bit as reset.

• syn — (Optional) Set the bit as synchronize.

• urg — (Optional) Set the bit set as urgent.

• host ip-address — (Optional) Enter the IP address to use a host address only.

Default Not congured

Command Mode IPV4-ACL

Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The

no version of this command removes the lter, or use the no seq sequence-number command if you know

the lter’s sequence number.

Example

OS10(config)# ip access-list egress

OS10(conf-ipv4-acl)# seq 10 deny udp any any capture session 1 count

Supported Releases 10.2.0E or later

seq deny udp (IPv6)

Assigns a lter to deny UDP packets while creating the lter.

Syntax

seq sequence-number deny udp [A::B | A::B/x | any | host ipv6-address [eq]]

[A::B | A:B/x | any | host ipv6-address [eq]] [ack | fin | psh | rst | syn |

urg] [capture | count [byte] | dscp value | fragment]

Parameters

• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing

number, from 0 to 2147483647.

• A::B — Enter the IPv6 address in hexadecimal format separated by colons.

• A::B/x — Enter the number of bits that must match the IPv6 address.

• any — (Optional) Set all routes which are subject to the lter:

• capture — (Optional) Capture packets the lter processes.

• count — (Optional) Count packets the lter processes.

• byte — (Optional) Count bytes the lter processes.

• dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.