Reference Guide

Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 0 to 2147483647.
• protocol-number — (Optional) Enter the protocol number, from 0 to 255.
• A::B — Enter the IPv6 address in hexadecimal format separated by colons.
• A::B/x — Enter the number of bits that must match the IPv6 address.
• any — (Optional) Set all routes which are subject to the lter:
• capture — (Optional) Enter to capture packets the lter processes.
• count — (Optional) Enter to count packets the lter processes.
• byte — (Optional) Enter to count bytes the lter processes.
• dscp value — (Optional) Enter the DSCP value to permit a packet, from 0 to 63.
• fragment — (Optional) Enter to use ACLs to control packet fragments.
• host ipv6-address — (Optional) Enter the IPv6 address to be used as the host address.
Default Not congured
Command Mode IPV6-ACL
Usage Information OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The
no version of this command removes the lter, or use the no seq sequence-number command if you know
the lter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 10 permit ipv6 any any capture session 1 count
Supported Releases 10.2.0E or later
seq permit (MAC)
Assigns a sequence number to permit MAC addresses while creating a lter.
Syntax
seq sequence-number permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any}
{nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos
| count [byte] | vlan]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing,
from 0 to 2147483647.
• nn:nn:nn:nn:nn:nn — Enter the MAC address of the network from or to which the packets were sent.
• 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not enter a
mask, a mask of 00:00:00:00:00:00 applies.
• any — (Optional) Set all routes to be subject to the lter:
• protocol-number — (Optional) Enter the protocol number identied in the MAC header, from 600 to
.
• capture — (Optional) Enter the capture packets the lter processes.
• cos — (Optional) Enter the CoS value, from 0 to 7.
• count — (Optional) Enter the count packets the lter processes.
• byte — (Optional) Enter the count bytes the lter processes.
• vlan — (Optional) Enter the VLAN number, from 1 to 4094.
Default Not congured
Access Control Lists 451