Reference Guide

• mac access-group name name — Enter an access-group name for the MAC access-list match criteria
(up to 140 characters).
• set dscp dscp-value — Enter a DSCP value for marking the DSCP packets (0 to 63).
• not — Enter the IP or CoS to negate the match criteria.
• vlan vlan-id — Enter a VLAN number for VLAN match criteria (1 to 4094).
Default Not congured
Command Mode CLASS-MAP
Usage Information In a match-any class, you can enter multiple match criteria. In a match-all class, if the match case is
access-group, no other match criteria is allowed. If you attach the access-list to class-map type
control—plane
, the access-list ignores the permit and deny keywords.
Example
OS10(conf-cmap-qos)# match ip access-group name ag1
Supported Releases 10.2.0E or later
match cos
Matches a cost of service (CoS) value to L2 dot1p packets.
Syntax
match [not] cos cos-value
Parameters
• cos-value — Enter a CoS value (0 to 7).
• not — Enter not to cancel the match criteria.
Default Not congured
Command Modes CLASS-MAP
Usage Information You cannot have two match statements with the same lter-type. If you enter two match statements with the
same lter-type, the second statement overwrites the rst statement.
Example
OS10(conf-cmap-qos)# match cos 3
Supported Releases 10.2.0E or later
match dscp
Congures a DSCP value as a match criteria for a class-map.
Syntax
match [not] {ip | ipv6 | ip-any } dscp [dscp-list | dscp-list]
Parameters
• not — (Optional) Enter to cancel a previously applied match criteria.
• ip — Enter to use IPv4 protocol as the match protocol.
• ipv6 — Enter to use IPv6 protocol as the match protocol.
• ip-any — Enter to use both IPv4 and IPv6 as the match protocol.
• dscp dscp-list | dscp-list — Enter a DSCP value in single numbers, comma separated, or a
hyphenated range (0 to 63).
Default Not congured
Quality of service 499