Reference Guide

1 Congure a platform-specic port prole in CONFIGURATION mode. For a standalone switch, enter 1/1 for node/unit.

switch-port-profile node/unit profile

2 Save the port prole change to the startup conguration in EXEC mode.

write memory

3 Reload the switch in EXEC mode.

reload

The switch reboots with the new port conguration and resets the system defaults, except for the switch-port prole and these congured

settings:

• Management interface 1/1/1 conguration

• Management IPv4/IPv6 static routes

• System hostname

• Unied Forwarding Table (UFT) mode

• ECMP maximum paths

You must manually recongure other settings on a switch after you apply a new port prole and reload the switch.

Congure port prole

OS10(config)# switch-port-profile 1/1 profile-6

OS10(config)# exit

OS10# write memory

OS10# reload

Verify port prole

OS10(config)# show switch-port-profile 1/1

|-------------+-------------------+-------------------|

Supported Profiles:

profile-1

profile-2

profile-3

profile-4

profile-5

profile-6

S4148-ON series port proles

On the S4148-ON series, port proles determine the available front-panel Ethernet ports and supported breakout interfaces on uplink ports.

In the port prole illustration, blue boxes indicate the supported ports and breakout interfaces. Blank spaces indicate ports and speeds that

are not available.

• 10GE mode is an SFP+ 10GE port or a 4x10G breakout of a QSFP+ or QSFP28 port.

• 25GE is a 4x25G breakout of a QSFP28 port.

• 40GE mode is a QSFP+ port or a QSFP28 port that supports QSFP+ 40GE transceivers.

• 50GE is a 2x50G breakout of a QSFP28 port.

• 100GE mode is a QSFP28 port.

NOTE

: For S4148U-ON port proles with both unied and Ethernet ports, see S4148U-ON port proles. An S4148U-ON unied

port supports Fibre Channel and Ethernet modes.

For example, profile-1 enables 10G speed on forty-eight ports (1-24 and 31-54), and 4x10G breakouts on QSFP28 ports 25-26 and

29-30; QSFP+ ports 27 and 28 are deactivated.

profile-3 enables 10G speed on forty ports, and 4x10G breakouts on all QSFP28 and

Interfaces