Reference Guide

Supported Releases 10.2.0E or later
interface null
Congures a null interface on the switch.
Syntax
interface null number
Parameters number — Enter the interface number to set as null (0).
Default 0
Command Mode CONFIGURATION
Usage Information You cannot delete the Null interface. The only conguration command possible in a Null interface is ip
unreachables.
Example
OS10(config)# interface null 0
OS10(conf-if-nu-0)#
Supported Releases 10.3.0E or later
interface port-channel
Creates a port-channel interface.
Syntax
interface port-channel channel-id
Parameters channel-id — Enter the port-channel ID number (1 to 128).
Default Not congured
Command Mode CONFIGURATION
Usage Information The no version of this command deletes the interface.
Example
OS10(config)# interface port-channel 10
OS10(conf-if-po-10)#
Supported Releases 10.2.0E or later
interface range
Congures a range of Ethernet, port-channel, or VLAN interfaces for bulk conguration.
Syntax
interface range {ethernet node/slot/port[:subport]-node/slot/port[:subport],
[...]} | {port-channel IDnumber-IDnumber,[ ...]} | vlan vlanID-vlanID,[...]}
Parameters
• node/slot/port[:subport]-node/slot/port[:subport] — Enter a range of Ethernet interfaces.
• IDnumber-IDnumber — Enter a range of port-channel numbers (1 to 128).
• vlanID-vlanID — Enter a range VLAN ID numbers (1 to 4094).
Default Not congured
Interfaces 89