Reference Guide

Command Mode CONFIGURATION
Usage
Information
● Each breakout interface operates at the configured speed; for example, 10G or 25G.
● The no interface breakout node/slot/port command resets a port to its default speed —
40G or 100G.
● To configure breakout interfaces on a unified port, use the mode {Eth | FC} command in the
Port-Group configuration mode.
Example
OS10(config)# interface breakout 1/1/41 map 10g-4x
Supported
Releases
10.2.2E or later
interface ethernet
Configures a physical Ethernet interface.
Syntax
interface ethernet node/slot/port:subport
Parameters node/slot/port:subport — Enter the Ethernet interface information.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command deletes the interface.
Example
OS10(config)# interface ethernet 1/1/10:1
OS10(conf-if-eth1/1/10:1)#
Supported
Releases
10.2.0E or later
interface loopback
Configures a loopback interface.
Syntax
interface loopback id
Parameters id — Enter the loopback interface ID number (0 to 16383).
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command deletes the loopback interface.
Example
OS10(config)# interface loopback 100
OS10(conf-if-lo-100)#
Supported
Releases
10.2.0E or later
interface mgmt
Configures the Management port.
Syntax
interface mgmt node/slot/port
Parameters node/slot/port — Enter the physical port interface information for the Management interface.
Interfaces 101