Reference Guide

Supported
Releases
10.4.0E(R1) or later
fcoe priority-bits
Configures the priority bits for FCoE application TLVs.
Syntax
fcoe priority-bits priority-value
Parameter priority-value — Enter PFC priority value advertised in FCoE application TLV. You can enter one of
the following values: 0x01, 0x02, 0x04, 0x08, 0x10, 0x20, 0x40, or 0x80.
Default 0x08
Command Mode CONFIGURATION
Usage
Information
You can configure only one PFC priority at a time. The no version of this command returns the
configuration to default value.
Example
OS10(config)# fcoe priority-bits 0x08
Supported
Releases
10.4.0E(R3) or later
lldp tlv-select dcbxp-appln fcoe
Enables FCoE application TLV for an interface.
Syntax
lldp tlv-select dcbxp-appln fcoe
Parameter None
Default Enabled
Command Mode INTERFACE
Usage
Information
The default priority value advertised in FCoE application TLV is 3. If the PFC configuration in an interface
matches 3, then the FCoE application TLV is advertised as 3. Otherwise, FCoE application TLV is not
advertised.
When you configure the application priority using fcoe priority-bits command, the configured
value is advertised in the TLV, which is not dependent on PFC configuration.
The no version of this command disables the FCoE application TLV.
Example
OS10(conf-if-eth1/1/1)# lldp tlv-select dcbx-appln fcoe
Supported
Releases
10.4.0E(R3) or later
show fcoe enode
Displays the details of ENodes connected to the switch.
Syntax
show fcoe enode [enode-mac-address]
Parameters enode-mac-address — (Optional) Enter the MAC address of ENode. This option displays details
pertaining to the specified ENode.
Default Not configured
Command Mode EXEC
Fibre Channel 139