Reference Guide

Supported
Releases
10.2.0E or later
spanning-tree bpdufilter
Enables or disables BPDU filtering on an interface.
Syntax
spanning-tree bpdufilter {enable | disable}
Parameters
● enable — Enables the BPDU filtering on an interface.
● disable — Disables the BPDU filtering on an interface.
Default Disabled
Command Mode INTERFACE
Usage
Information
Use the enable parameter to enable BPDU filtering.
Example
OS10(conf-if-eth1/1/4)# spanning-tree bpdufilter enable
Supported
Releases
10.2.0E or later
spanning-tree bpduguard
Enables or disables BPDU guard on an interface.
Syntax
spanning-tree bpduguard {enable | disable}
Parameters
● enable — Enables the BPDU guard filter on an interface.
● disable — Disables the BPDU guard filter on an interface.
Default Disabled
Command Mode INTERFACE
Usage
Information
BPDU guard prevents a port from receiving BPDUs. If the port receives a BPDU, it is placed in the
Error-Disabled state as a protective measure.
Example
OS10(conf-if-eth1/1/4)# spanning-tree bpduguard enable
Supported
Releases
10.2.0E or later
spanning-tree disable
Disables the spanning-tree mode configured with the spanning-tree mode command globally on the switch or on specified
interfaces.
Syntax
spanning-tree disable
Parameters None
Default Not configured.
Usage
Information
The no version of this command re-enables STP and applies the currently configured spanning-tree
settings.
Command Mode
CONFIGURATION
INTERFACE
Layer 2 205