Reference Guide

● vrf-name—Enter the name of the non-default VRF instance to configure a domain name for that
VRF instance.
● domain-name—Enter the domain name.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the host name from the management or non-default VRF
instance.
Example
OS10(config)# ip domain-name vrf management dell.com
or
OS10(config)# ip domain-name vrf blue dell.com
Supported
Releases
10.4.0E(R1) or later
ip vrf
Create a non-default VRF instance.
Syntax
ip vrf vrf-name
Parameters
● vrf-name—Enter the name of the non-default VRF that you want to create. Enter a VRF name that
is not greater than 32 characters in length.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
Enter the ip vrf vrf-name command only in non-transaction-based configuration mode. Do not use
transaction-based mode. You can create up to a maximum of 16 non-default VRF instances. The no ip
vrf vrf-name command removes the non-default VRF instance that you specify.
Example
OS10(config)# ip vrf vrf-test
OS10(conf-vrf-test)#
Supported
Releases
10.4.1.0 or later
ip ftp vrf
Configures an FTP client for the management VRF instance.
Syntax
ip ftp vrf management
Parameters None
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the management VRF instance configuration from the FTP
client.
Example
OS10(config)# ip ftp vrf management
Supported
Releases
10.4.0E(R1) or later
264 Layer 3