Reference Guide

-- Power Supplies --
PSU-ID Status Type AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 up AC NORMAL 1 11872 up
2 fail
-- Fan Status --
FanTray Status AirFlow Fan Speed(rpm) Status
----------------------------------------------------------------
1 up NORMAL 1 10570 up
2 10598 up
2 up NORMAL 1 10541 up
2 10656 up
3 up NORMAL 1 10598 up
2 10802 up
4 up NORMAL 1 10485 up
2 10714 up
Candidate configuration
When you enter OS10 configuration commands in the transaction-based configuration mode, changes do not take effect
immediately and are stored in the candidate configuration. The configuration changes become active on the network device only
after you commit the changes with the commit command. Changes in the candidate configuration are validated and applied to
the running configuration.
The candidate configuration allows you to avoid introducing errors during an OS10 configuration session. You can make changes
and then check them before committing them to the active, running configuration on the network device.
Use the show diff command to check differences between the running configuration and the candidate configuration. After
comparing the two, you can decide if you would like to commit the changes to the running configuration. Use the discard
command to delete uncommitted changes.
● Enter show ? from EXEC mode to view a list of commands to monitor a device.
OS10# show ?
aaa Current candidate aaa configuration
access-list Current candidate access-list configuration
as-path Current candidate as-path configuration
bgp Current candidate bgp configuration
class-map Current candidate class-map configuration
community-list Current candidate community-list configuration
compressed Current candidate configuration in compressed format
control-plane Current candidate control-plane configuration
dot1x Current candidate dot1x configuration
extcommunity-list Current candidate extcommunity-list configuration
interface Current candidate interface configuration
lacp Current candidate lacp configuration
lldp Current candidate lldp configuration
logging Current candidate logging configuration
monitor Current candidate monitor session configuration
ospf Current candidate ospf configuration
ospfv3 Current candidate ospfv3 configuration
policy-map Current candidate policy-map configuration
prefix-list Current candidate prefix-list configuration
qos-map Current candidate qos-map configuration
radius-server Current candidate radius-server configuration
route-map Current candidate route-map configuration
sflow Current candidate sFlow configuration
snmp Current candidate snmp configuration
spanning-tree Current candidate spanning-tree configuration
support-assist Current candidate support-assist configuration
system-qos Current candidate system-qos configuration
trust-map Current candidate trust-map configuration
Getting Started
39