Reference Guide

View monitor sessions
OS10(conf-if-eth1/1/1)# show monitor session all
S.Id Source Destination Dir SrcIP DstIP DSCP TTL State Reason
----------------------------------------------------------------------------
1 ethernet1/1/1 ethernet1/1/4 both N/A N/A N/A N/A true Is UP
ACL commands
clear ip access-list counters
Clears ACL counters for a specific access-list.
Syntax
clear ip access-list counters [access-list-name]
Parameters access-list-name — (Optional) Enter the name of the IP access-list to clear counters. A maximum
of 140 characters.
Default Not configured
Command Mode EXEC
Usage
Information
If you do not enter an access-list name, all IPv6 access-list counters clear. The counter counts the
number of packets that match each permit or deny statement in an access-list. To get a more recent
count of packets matching an access list, clear the counters to start at zero. To view access-list
information, use the show access-lists command.
Example
OS10# clear ip access-list counters
Supported
Releases
10.2.0E or later
clear ipv6 access-list counters
Clears IPv6 access-list counters for a specific access-list.
Syntax
clear ipv6 access-list counters [access-list-name]
Parameters access-list-name — (Optional) Enter the name of the IPv6 access-list to clear counters. A maximum
of 140 characters.
Default Not configured
Command Mode EXEC
Usage
Information
If you do not enter an access-list name, all IP access-list counters clear. The counter counts the number
of packets that match each permit or deny statement in an access list. To get a more recent count of
packets matching an access list, clear the counters to start at zero. To view access-list information, use
the show access-lists command.
Example
OS10# clear ipv6 access-list counters
Supported
Releases
10.2.0E or later
clear mac access-list counters
Clears counters for a specific or all MAC access lists.
Syntax
clear mac access-list counters [access-list-name]
574 Access Control Lists