Reference Guide

○ eq — Equal to
○ gt — Greater than
○ lt — Lesser than
○ neq — Not equal to
○ range — Range of ports, including the specified port numbers.
● host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.
Default Not configured
Command Mode IPV6-ACL
Usage
Information
The no version of this command removes the filter.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# deny tcp any any capture session 1
Supported
Releases
10.2.0E or later
deny udp
Configures a filter to drop User Datagram Protocol (UDP) packets meeting the filter criteria.
Syntax
deny udp [A.B.C.D | A.B.C.D/x | any | host ip-address [operator]] [A.B.C.D
| A.B.C.D/x | any | host ip-address [operator]] [ack | fin | psh | rst |
syn | urg] [capture | dscp value | fragment]
Parameters
● A.B.C.D — Enter the IP address in dotted decimal format.
● A.B.C.D/x — Enter the number of bits to match to the dotted decimal address.
● any — (Optional) Set all routes which are subject to the filter:
○ capture — (Optional) Capture packets the filter processes.
○ dscp value — (Optional) Deny a packet based on the DSCP values, from 0 to 63.
○ fragment — (Optional) Use ACLs to control packet fragments.
○ ack — (Optional) Set the bit as acknowledgement.
○ fin — (Optional) Set the bit as finish—no more data from sender.
○ psh — (Optional) Set the bit as push.
○ rst — (Optional) Set the bit as reset.
○ syn — (Optional) Set the bit as synchronize.
○ urg — (Optional) Set the bit set as urgent.
● operator — (Optional) Enter a logical operator to match the packets on the specified port number.
The following options are available:
○ eq — Equal to
○ gt — Greater than
○ lt — Lesser than
○ neq — Not equal to
○ range — Range of ports, including the specified port numbers.
● host ip-address — (Optional) Enter the IP address to use a host address only.
Default Not configured
Command Mode IPV4-ACL
Usage
Information
The no version of this command removes the filter.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# deny udp any any capture session 1
580 Access Control Lists