Reference Guide

● any — (Optional) Set all routes which are subject to the filter:
○ capture — (Optional) Enter to capture packets the filter processes.
○ dscp value — (Optional) Enter the DSCP value to permit a packet, from 0 to 63.
○ fragment — (Optional) Enter to use ACLs to control packet fragments.
● host ipv6-address — (Optional) Enter the IPv6 address to be used as the host address.
Default Not configured
Command Mode IPV6-ACL
Usage
Information
The no version of this command removes the filter, or use the no seq sequence-number command if
you know the filter’s sequence number.
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 10 permit ipv6 any any capture session 1
Supported
Releases
10.2.0E or later
seq permit (MAC)
Assigns a sequence number to permit MAC addresses while creating a filter.
Syntax
seq sequence-number permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any}
{nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture |
cos | vlan]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing, from 1 to 16777214.
● nn:nn:nn:nn:nn:nn — Enter the MAC address of the network from or to which the packets were
sent.
● 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not
enter a mask, a mask of 00:00:00:00:00:00 applies.
● any — (Optional) Set all routes to be subject to the filter:
○ protocol-number — (Optional) Enter the protocol number identified in the MAC header, from
600 to ffff.
○ capture — (Optional) Enter the capture packets the filter processes.
○ cos — (Optional) Enter the CoS value, from 0 to 7.
○ vlan — (Optional) Enter the VLAN number, from 1 to 4093.
Default Not configured
Command Mode MAC-ACL
Usage
Information
The no version of this command removes the filter, or use the no seq sequence-number command if
you know the filter’s sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 permit 00:00:00:00:11:11 00:00:11:11:11:11
any cos 7
OS10(conf-mac-acl)# seq 20 permit 00:00:00:00:11:11 00:00:11:11:11:11
any vlan 2
Supported
Releases
10.2.0E or later
Access Control Lists 605