Reference Guide

seq permit ip
Assigns a sequence number to allow packets while creating the filter.
Syntax
seq sequence-number permit ip [A.B.C.D | A.B.C.D/x | any | host ip-address]
[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | dscp value|
fragment]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
● A.B.C.D — Enter the IP address in dotted decimal format.
● A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
● any — (Optional) Set all routes which are subject to the filter:
○ capture — (Optional) Capture packets the filter processes.
○ dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
○ fragment — (Optional) Use ACLs to control packet fragments.
● host ip-address — (Optional) Enter the IP address to use a host address only.
Default Not configured
Command Mode IPV4-ACL
Usage
Information
The no version of this command removes the filter, or use the no seq sequence-number command if
you know the filter’s sequence number.
Example
OS10(config)# ip access-list egress
OS10(conf-ipv4-acl)# seq 5 permit ip any any capture session 1
Supported
Releases
10.2.0E or later
seq permit ipv6
Assigns a sequence number to allow packets while creating the filter.
Syntax
seq sequence-number permit ipv6 [A::B | A::B/x | any | host ipv6-address]
[A::B | A:B/x | any | host ipv6-address] [capture | dscp value | fragment]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
● A::B — Enter the IPv6 address in hexadecimal format separated by colons.
● A::B/x — Enter the number of bits that must match the IPv6 address.
● any — (Optional) Set all routes which are subject to the filter:
○ capture — (Optional) Capture packets the filter processes.
○ dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
○ fragment — (Optional) Use ACLs to control packet fragments.
● host ipv6-address — (Optional) Enter the IPv6 address to use a host address only.
Default Not configured
Command Mode IPV6-ACL
Usage
Information
The no version of this command removes the filter, or use the no seq sequence-number command if
you know the filter’s sequence number.
Example
OS10(config)# ipv6 access-list egress
OS10(conf-ipv6-acl)# seq 5 permit ipv6 any any capture session 1
Supported
Releases
10.2.0E or later
Access Control Lists 607