Connectivity Guide

Example
OS10(conf-if-fc-1/1/2)# speed 16
Supported Releases 10.3.1E or later
speed (Management)
Congures the transmission speed of the Management interface.
Syntax
speed {10 | 100 | 1000 | auto}
Parameters Set the Management port speed to:
• 10 — 10M
• 100 — 100M
• 1000 — 1000M
• auto — Set the port to auto-negotiate speed with a connected device.
Defaults Auto
Command Mode INTERFACE
Usage Information
The speed command is supported only on Management and Fibre Channel interfaces. This command is not
supported on Ethernet interfaces.
• When you manually congure the Management port speed, match the speed of the remote device. Dell EMC
highly recommends using auto-negotiation for the Management port.
•
The no version of this command resets the port speed to the default value auto.
Example
OS10(conf-if-ma-1/1/1)# speed auto
Supported Releases 10.3.0E or later
switch-port-prole
Congures a port prole on the switch. The port prole determines the available front-panel ports and breakout modes.
Syntax
switch-port-profile node/unit profile
Parameters
• node/unit — Enter switch information. For a standalone switch, enter 1/1.
• profile — Enter the name of a platform-specic prole.
Default
profile-1
Command Mode CONFIGURATION
Usage Information
• S4148-ON Series port proles:
– profile-1 — SFP+ 10G ports (1-24 and 31-54) and QSFP28 100G ports (25-26 and 29-30) are enabled.
QSFP28 ports support 100GE and 4x10G, 4x25G, and 2x50G breakouts.
– profile-2 — SFP+ 10G ports (1-24 and 31-50), QSFP+ 40G ports (27-28), and QSFP28 ports in 40G
mode (25-26 and 29-30) are enabled.
QSFP+ and QSFP28 ports support 40GE and 4x10G breakouts.
Interfaces 123