Connectivity Guide

seq permit
Assigns a sequence number to permit packets while creating the lter.
Syntax
seq sequence-number permit [protocol-number A.B.C.D | A.B.C.D/x | any | host
ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | dscp
value| fragment]]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 1 to 16777214.
• protocol-number — (Optional) Enter the protocol number, from 0 to 255.
• A.B.C.D — Enter the IPv4 address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Set all routes which are subject to the lter:
– capture — (Optional) Capture packets the lter processes.
– dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
– fragment — (Optional) Use ACLs to control packet fragments.
• host ip-address — (Optional) Enter the IPv4 address to use a host address only.
Default Not congured
Command Mode IPV4-ACL
Usage Information The no version of this command removes the lter.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# seq 10 permit ip any any capture session 1
Supported Releases 10.2.0E or later
seq permit (IPv6)
Assigns a sequence number to permit IPv6 packets, while creating a lter.
Syntax
seq sequence-number permit protocol-number [A::B | A::B/x | any | host ipv6-
address] [A::B | A:B/x | any | host ipv6-address] [capture | dscp value |
fragment]
Parameters
• sequence-number — Enter the sequence number to identify the route-map for editing and sequencing
number, from 1 to 16777214.
• protocol-number — (Optional) Enter the protocol number, from 0 to 255.
• A::B — Enter the IPv6 address in hexadecimal format separated by colons.
• A::B/x — Enter the number of bits that must match the IPv6 address.
• any — (Optional) Set all routes which are subject to the lter:
– capture — (Optional) Enter to capture packets the lter processes.
– dscp value — (Optional) Enter the DSCP value to permit a packet, from 0 to 63.
– fragment — (Optional) Enter to use ACLs to control packet fragments.
• host ipv6-address — (Optional) Enter the IPv6 address to be used as the host address.
746 Access Control Lists