Connectivity Guide

• sequence-number — (Optional) Enter the number to identify the route-map for editing and sequencing
number from 1 to 65535. The default is 10.
• permit — (Optional) Set the route-map default as permit.
• deny — (Optional) Set the route default as deny.
Default Not congured
Command Mode CONFIGURATION
Usage Information
NOTE: Exercise caution when you delete route-maps — if you do not enter a sequence number, all
route-maps with the same map-name are deleted.
The no version of this command removes a route-map.
Example
OS10(config)# route-map route1 permit 100
OS10(config-route-map)#
Supported Releases 10.2.0E or later
set comm-list add
Add communities in the specied list to the COMMUNITY attribute in a matching inbound or outbound BGP route.
Syntax
set comm-list {community-list-name} add
Parameters community-list-name — Enter the name of an established community list. A maximum of 140 characters.
Defaults None
Command Mode ROUTE-MAP
Usage Information In a route map, use this set command to add a list of communities that pass a permit statement to the
COMMUNITY attribute of a BGP route sent or received from a BGP peer. Use the set comm-list delete
command to delete a community list from a matching route.
Example
OS10(config)# route-map bgp
OS10(conf-route-map)# set comm-list comlist1 add
Supported Releases 10.4.0E(R1) or later
set comm-list delete
Remove communities in the specied list from the COMMUNITY attribute in a matching inbound or outbound BGP route.
Syntax
set comm-list {community-list-name} delete
Parameters community-list-name — Enter the name of an established community list. A maximum of 140 characters.
Defaults None‘
Command Mode ROUTE-MAP
Usage Information
Congure the community list you use in the set comm-list delete command so that each lter contains
only one community. For example, the lter deny 100:12 is acceptable, but the lter deny 120:13 140:33
results in an error. If you congure the set comm-list delete command and the set community
command in the same route map sequence, the deletion set comm-list delete command processes before
Access Control Lists 767