Connectivity Guide

trust dscp-map
Creates a user-dened trust map for DSCP ows.
Syntax
trust dscp-map map-name
Parameters map-name — Enter the name of the DSCP trust map. A maximum of 32 characters.
Default Not congured
Command Mode CONFIGURATION
Usage Information If you enable trust, trac obeys this trust map. default-dscp-trust is a reserved trust-map name. The no
version of this command returns the value to the default.
Example
OS10(config)# trust dscp-map dscp-trust1
Supported Releases 10.3.0E or later
qos-map trac-class
Creates a user-dened trust map for queue mapping. In S5148F-ON, apply the trac class only on the egress trac.
Syntax
qos-map traffic-class map-name
Parameters map-name — Enter the name of the queue trust map. A maximum of 32 characters.
Default Not congured
Command Mode CONFIGURATION
Usage Information If applied on the interface or system level, the trac class routes all trac to the mapped queue. The no version of
this command returns the value to the default.
Example
OS10(config)# qos-map traffic-class queue-map1
OS10(config-qos-map)# queue 1 qos-group 5
OS10(config-qos-map)# queue 2 qos-group 6
OS10(config-qos-map)# queue 3 qos-group 7
OS10(config-qos-map)#
Supported Releases 10.3.0E or later
trust-map
Applies a dot1p or DSCP trac class to a queue trust map.
Syntax
trust {dot1p | dscp} {default | trust-map-name}
Parameters
• dot1p— Applies a dot1p trust map.
• dscp—Applies a dscp trust map.
• default— Applies a default trust map.
Default Disabled
1032 Quality of service