Connectivity Guide

Example
OS10(config)# vlt-domain 1
OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15
Example (range)
OS10(config)# vlt-domain 2
OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/12
Supported Releases 10.2.0E or later
peer-routing
Enables or disables L3 routing to peers.
Syntax
peer-routing
Parameters None
Default Disabled
Command Mode VLT-DOMAIN
Usage Information The no version of this command disables L3 routing.
Example
OS10(conf-vlt-1)# peer-routing
Supported Releases 10.2.0E or later
peer-routing-timeout
Congures the delay after which peer routing disables when the peer is not available. This command supports both IPv6 and IPv4.
Syntax
peer-routing-timeout value
Parameters value — Enter the timeout value in seconds, from 0 to 65535.
Default 0
Command Mode VLT-DOMAIN
Usage Information
When the timer expires, the software checks to see if the VLT peer is available. If the VLT peer is not available,
peer-routing disables on the peer. If you do not congure the timer, peer-routing does not disable even when the
peer is unavailable.
Example
OS10(conf-vlt-1)# peer-routing-timeout 120
Supported Releases 10.3.0E or later
primary-priority
Congures the priority when selecting the primary and secondary VLT peers during election.
Syntax
primary-priority value
Parameters value — Enter a lower value than the priority value of the remote peer. The range is from 1 to 65535. The default
value is 32768.
1060 Virtual Link Trunking