Connectivity Guide
• If the iSCSI login request is received on a non-VLT interface, followed by a response from a VLT interface, the connection is associated
with the VLT LAG interface and the information about the session synchronizes with the VLT peer.
• When a VLT interconnect comes up, information about iSCSI sessions learnt on the VLT LAG exchanges between the VLT-peers.
iSCSI commands
iscsi aging
Sets the aging time for monitored iSCSI sessions.
Syntax
iscsi aging [time minutes]
Parameters time minutes — Enter the aging time in minutes allowed for monitoring iSCSI sessions, from 5 to 43,200.
Default 10 minutes
Command Mode CONFIGURATION
Usage Information Congure the aging time allowed for monitored iSCSI sessions on TCP ports before the session closes. The no
version of this command disables the aging time.
Example
OS10(config)# iscsi aging time 30
Supported Releases 10.3.0E or later
iscsi enable
Enables iSCSI auto-detection of attached storage arrays and switch auto-conguration.
Syntax
iscsi enable
Parameter None
Default
None
Command Mode CONFIGURATION
Usage Information
iSCSI optimization automatically detects storage arrays and auto-congures switch ports with the iSCSI
parameters received from a connected device. The no version of this command disables iSCSI auto-detection.
Starting from release 10.4.1.1, when you perform a fresh installation of OS10, iSCSI autocong is enabled and
owcontrol receive is set to on. However, when you upgrade from an earlier release to release 10.4.1.1 or later, the
existing iSCSI conguration is retained and the owcontrol receive could be set to on or o, depending on the
iSCSI conguration before upgrade.
Example
OS10(config)# iscsi enable
Supported Releases 10.3.0E or later
1108 Converged data center services