Connectivity Guide
Usage information When an error condition occurs, use the debug telemetry command to store telemetry data in a debug le.
The telemetry debug le is stored at /var/log/grpc_server.log.
Example
OS10# debug telemetry
Supported releases 10.4.3.0 or later
destination
Congures a destination management device that receives streaming telemetry.
Syntax
destination {ip-address | domain-name} port-number
Parameters
• ip-address — Enter the IPv4 or IPv6 address of the destination device. You can enter a fully qualied
domain name (FQDN). The destination domain name resolves to an IP address — see System domain name
and list.
• domain-name — Enter the fully qualied domain name of the destination device. A maximum of 32
characters.
•
port-number — Enter the transport-service port number to which telemetry data is sent on the destination
device.
Default Not congured
Command mode DESTINATION-GROUP
Usage information When you associate a destination group with a subscription, telemetry data is sent to the IP address and port
specied by the destination command. In the 10.4.3.0 release, only one destination is supported. The no
version of this command removes the congured destination.
Example
OS10(conf-telemetry)# destination-group dest1
OS10(conf-telemetry-dg-dest1)# destination 10.11.56.204 40001
OS10(conf-telemetry-dg-dest1)#
Supported releases 10.4.3.0 or later
destination-group (subscription-prole)
Assigns a destination group to a subscription prole for streaming telemetry.
Syntax
destination-group group-name
Parameters group-name — Enter the name of the destination group. A maximum of 32 characters.
Default Not congured
Command mode SUBSCRIPTION-PROFILE
Usage information A subscription prole associates destination groups and sensor groups. A destination group denes the destination
servers to which streaming telemetry data is sent. The no version of this command removes the congured group
from the subscription prole.
Example
OS10(conf-telemetry)# subscription-profile subscription-1
OS10(conf-telemetry-sp-subscription-1)# destination-group dest1
Supported releases 10.4.3.0 or later
1136 Telemetry