Connectivity Guide
Command Mode DHCP-POOL
Usage Information Use this command to congure a range of IPv4 or IPv6 addresses.
Example
OS10(config-dhcp-Dell)# network 20.1.1.1/24
Supported Releases 10.2.0E or later
pool
Creates an IP address pool name.
Syntax
pool pool-name
Parameters pool-name — Enter the DHCP server pool name.
Default Not congured
Command Mode CONFIGURATION
Usage Information Use this command to create an IP address pool name.
Example
OS10(conf-dhcp)# pool Dell
OS10(conf-dhcp-Dell)#
Supported Releases 10.2.0E or later
range
Congures a range of IP addresses.
Syntax
range {ip-address1 [ip-address2]}
Parameters
• ip-address1—First IP address of the IP address range.
• ip-address2—Last IP address of the IP address range.
Default Not congured
Command Mode DHCP-POOL
Usage Information This command is used to congure a range of IP addresses that the OS10 switch, acting as the DHCP server, can
assign to DHCP clients. The no version of this command requires only the rst IP address to remove the range
conguration.
Example
OS10(config)# OS10(config)# ip dhcp server
OS10(config-dhcp)# pool pool1
OS10(config-dhcp-pool1)# network 192.168.10.0/24
OS10(config-dhcp-pool1)# range 192.168.10.2 192.168.10.8
Supported Releases 10.4.1 or later
show ip dhcp binding
Displays the DHCP binding table with IPv4 addresses.
Syntax
show ip dhcp binding
System management 143