Connectivity Guide
3 Congure an IP address and mask on the Management interface in INTERFACE mode.
ip address A.B.C.D/prefix-length
4 Enable the Management interface in INTERFACE mode.
no shutdown
Congure management interface
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# no ip address dhcp
OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24
OS10(conf-if-ma-1/1/1)# no shutdown
VLAN interfaces
VLANs are logical interfaces and are, by default, in L2 mode. Physical interfaces and port-channels can be members of VLANs.
OS10 supports inter-VLAN routing. You can add IP addresses to VLANs and use them in routing protocols in the same manner that physical
interfaces are used.
When using VLANs in a routing protocol, you must congure the no shutdown command to enable the VLAN for routing trac. In
VLANs, the shutdown command prevents L3 trac from passing through the interface. L2 trac is unaected by this command.
• Congure an IP address in A.B.C.D/x format on the interface in INTERFACE mode. The secondary IP address is the interface’s backup
IP address.
ip address ip-address/mask [secondary]
Congure VLAN
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)# ip address 1.1.1.2/24
You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.
User-congured default VLAN
By default, VLAN1 serves as the default VLAN for switching untagged L2 trac on OS10 ports in Trunk or Access mode. The default VLAN
is used for untagged protocol trac sent and received between switches, such as STPs. If you use VLAN1 for data trac for network-
specic needs, recongure the VLAN ID of the default VLAN.
• Assign a new VLAN ID to the default VLAN in CONFIGURATION mode, from 1 to 4093.
default vlan-id vlan-id
In the show vlan output, an asterisk (*) indicates the default VLAN.
Recongure default VLAN
OS10# show vlan
Q: A - Access (Untagged), T - Tagged
NUM Status Description Q Ports
* 1 up A Eth1/1/1-1/1/25,1/1/29,1/1/31-1/1/54
OS10(config)# interface vlan 10
Sep 19 17:28:10 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:notify],
%Dell EMC (OS10) %IFM_ASTATE_UP: Interface admin state up :vlan10
OS10(conf-if-vl-10)# exit
OS10(config)# default vlan-id 10
Sep 19 17:28:15 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:trap], %Dell EMC (OS10)
%IFM_OSTATE_DN: Interface operational state is down :vlan1
Sep 19 17:28:16 OS10 dn_ifm[932]: Node.1-Unit.1:PRI:notice [os10:trap], %Dell EMC (OS10)
%IFM_OSTATE_UP: Interface operational state is up :vlan10
154
Interfaces