Connectivity Guide
Example
OS10(config)# vfabric 100
OS10(conf-vfabric-100)# zoneset activate set
Supported Releases 10.3.1E or later
NPG commands
The following commands are supported on NPG mode:
fc port-mode F
Congures port mode on Fibre Channel interfaces.
Syntax
fc port-mode F
Parameters None
Defaults N_Port
Command Mode Fibre Channel INTERFACE
Usage Information Congure the port mode when the port is in Shut mode and when NPG mode is enabled. The no version of this
command returns the port mode to default.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# fc port-mode F
Supported Releases 10.4.1.0 or later
feature fc npg
Enables the NPG mode globally.
Syntax
feature fc npg
Parameters None
Defaults Disabled
Command Mode CONFIGURATION
Usage Information
You can enable only one of the following at a time: F_Port, NPG, or FSB. The no version of this command disables
NPG mode.
Example
OS10(config)# feature fc npg
Supported Releases 10.4.0E(R1) or later
show npg devices
Displays the NPG devices connected to the switch.
Syntax
show npg devices [brief]
Fibre Channel 239