Connectivity Guide

Default Not congured
Command Mode
CONFIGURATION
CONTROL-PLANE
Usage Information Use this command in the CONTROL-PLANE mode to apply a control-plane ACL. Control-plane ACLs are only
applied on the ingress trac. By default, the control-plane ACL is applied to the front-panel ports. The no version
of this command resets the value to the default.
Example
OS10(config)# mac access-group maclist in
OS10(conf-mac-acl)#
Example (Control-
plane ACL)
OS10# configure terminal
OS10(config)# control-plane
OS10(config-control-plane)# mac access-group maclist in
Supported Releases 10.2.0E or later; 10.4.1 or later (control-plane ACL)
mac access-list
Creates a MAC access list to lter based on a MAC address.
Syntax
mac access-list access-list-name
Parameters access-list-name — Enter the name of a MAC access list. A maximum of 140 characters.
Default Not congured
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# mac access-list maclist
Supported Releases 10.2.0E or later
permit
Congures a lter to allow packets with a specic IPv4 address.
Syntax
permit [protocol-number | icmp | ip | tcp | udp] [A.B.C.D | A.B.C.D/x | any |
host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count
| dscp value | fragment | log]
Parameters
• protocol-number — (Optional) Enter the protocol number identied in the IP header, from 0 to 255.
• icmp — (Optional) Enter the ICMP address to permit.
• ip — (Optional) Enter the IPv4 address to permit.
• tcp — (Optional) Enter the TCP address to permit.
• udp — (Optional) Enter the UDP address to permit.
• A.B.C.D — Enter the IPv4 address in dotted decimal format.
• A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
• any — (Optional) Enter the keyword any to specify any source or destination IP address.
914 Access Control Lists