Connectivity Guide

0 0,1,2,3, 30% ETS
1 4,5,6,7 70% ETS
2 0% SP
3 0% SP
4 0% SP
5 0% SP
6 0% SP
7 0% SP
Remote Willing Status is disabled
Local Parameters :
-------------------
Local is enabled
PG-grp Priority# Bandwidth TSA
------------------------------------------------
0 0,1,2,3, 30% ETS
1 4,5,6,7 70% ETS
2 0% ETS
3 0% ETS
4 0% ETS
5 0% ETS
6 0% ETS
7 0% ETS
Oper status is init
ETS DCBX Oper status is Up
State Machine Type is Asymmetric
Conf TLV Tx Status is enabled
Reco TLV Tx Status is enabled
2 Input Conf TLV Pkts, 27 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
2 Input Reco TLV Pkts, 27 Output Reco TLV Pkts, 0 Error Reco TLV Pkts
10. iSCSI optimization conguration (global)
This example accepts the default settings for aging time and TCP ports used in monitored iSCSi sessions. A Compellant storage array is
connected to the port. The policy-iscsi policy map sets the CoS dot1p priority used for iSCSI trac to 6 globally on the switch. By default,
iSCSI trac uses priority 4. The
iscsi priority-bits 0x40 command sets the advertised dot1p priority used by iSCSI trac in
application TLVs to 6. Hexadecimal 0x40 is binary 0 1 0 0 0 0 0 0.
OS10(conf-if-eth1/1/53)# iscsi profile-storage compellent
OS10(conf-if-eth1/1/53)# lldp tlv-select dcbxp-appln iscsi
OS10(conf-if-eth1/1/53)# exit
OS10(config)# iscsi target port 3261 ip-address 10.1.1.1
OS10(config)# policy-map type application policy-iscsi
OS10(config-pmap-application)# class class-iscsi
OS10(config-pmap-c-app)# set qos-group 6
OS10(config-pmap-c-app)# set cos 6
OS10(config-pmap-c-app)# exit
OS10(config-pmap-application)# exit
OS10(config)# system qos
OS10(config-sys-qos)# service-policy type application policy-iscsi
OS10(config-sys-qos)# exit
OS10(config)# iscsi session-monitoring enable
OS10(config)# iscsi priority-bits 0x40
OS10(config)# iscsi enable
11. Verify iSCSI optimization (global)
Converged data center services
903