Users Guide

23 Dell EMC Networking ONIE Quick Start Guide
A Manually assign an IP address
To manually assign an IP address:
1. Enter the following command to stop the ONIE discovery process:
onie-discovery-stop
2. If a DHCP server is not used, configure the IP address and subnet mask on the management port,
where x.x.x.x represents your internal IP address.
ifconfig eth0 x.x.x.x netmask 255.255.255.0 up
3. Use the following command to verify that the IP address has been assigned to eth0:
ONIE:/ # ifconfig
eth0 Link encap:Ethernet HWaddr 14:18:77:E0:69:31
inet addr:100.67.170.221 Bcast:100.67.170.255
Mask:255.255.255.0
inet6 addr: fe80::1618:77ff:fee0:6931/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:28 errors:0 dropped:0 overruns:0 frame:0
TX packets:13 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:11176 (10.9 KiB) TX bytes:2712 (2.6 KiB)
Memory:dfe60000-dfe7ffff
4. If the server is in a separate subnet, add a default route using the following command:
ONIE:/ # route add default gw 100.67.170.254
5. Verify the default route was successfully created.
ONIE:/ # route -n
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
0.0.0.0 100.67.170.254 0.0.0.0 UG 0 0 0 eth0
100.67.170.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
Note: This process is not persistent and will need to be reconfigured after a reboot.