Users Guide

25 Dell EMC Networking ONIE Quick Start Guide
Slave CPLD Version : 5
Packed CPLD image Info:
Packed System CPLD Version : 15.2
Packed Master CPLD Version : 12
Packed Slave CPLD Version : 5
PPId Info:
PPId : TW0J09D32829849Q0048
PPId Revision : X01
SysEeprom Info:
Base MAC Address : 34:17:eb:f2:52:c4
Country Code : TW
Part Number : 0J09D3
Manufacturer : 28298
Manufacture Date : 10/03/2014 13:39:37
Product Name :
B.1 DCLI upgrade
To verify the current version of DIAGs installed:
1. Access the Platform-DIAGs menu.
2. From the DIAGs DCLI command prompt, enter the showSystemInfo command to verify the current
version. The version of the DIAGs is also presented during the loading process.
Note: This example was done using the Dell EMC Networking S4048-ON. For current DCLI diagnostic
versions, see the Release Notes specific to your switch.
If a newer version of DIAGs is needed, update the DIAGs using the following steps:
3. Login to ONIE: Update sub menu.
4. Run the onie-discover-stop command to disable the onie auto discovery process.
5. Ensure that the most current version of the INSTALLER-DND-SK-x.x.x.x.bin file has been
downloaded from the support site and placed in the TFTP server.
Note: Download the INSTALLER-DND-SG-<version>.bin file from support.dell.com. Navigate to the specific
Dell EMC networking device page. Go to Drivers and downloads > Dell Networking Diagnostics for <switch>
Open Networking Switch and then select view full driver details.
6. Run the following command to download and install the file:
ONIE:/ # onie-nos-install tftp://<ip address>/INSTALLER-DND-SK-
<version>.bin
The following output should be expected:
ONIE:/ # onie-nos-install tftp://<ip address>/INSTALLER-DND-SK-
1.0.0.14.bin
Discover: Rescue mode detected. No discover stopped.