Users Guide

speed (Fibre Channel)
Configures the transmission speed of a Fibre Channel interface.
Syntax
speed {8 | 16 | 32 | auto}
Parameters Set the speed of a Fibre Channel interface to:
● 8 — 8GFC
● 16 — 16GFC
● 32 — 32GFC
● auto — Set the port speed to the speed of the installed media.
Defaults Auto
Command Mode INTERFACE
Usage
Information
● To configure oversubscription for bursty storage traffic on a FC interface, use the speed command.
Oversubscription allows a port to operate faster, but may result in traffic loss. QSFP28 breakout
interfaces in 4x16GFC mode support 32GFC oversubscription.
● The no version of this command resets the port speed to the default value auto.
Example
OS10(conf-if-fc-1/1/2)# speed 16
Supported
Releases
10.3.1E or later
speed (Management)
Configures the transmission speed of the Management interface.
Syntax
speed {10 | 100 | 1000 | auto}
Parameters Set the Management port speed to:
● 10 — 10M
● 100 — 100M
● 1000 — 1000M
● auto — Set the port to auto-negotiate speed with a connected device.
Defaults Auto
Command Mode INTERFACE
Usage
Information
● When you manually configure the Management port speed, match the speed of the remote device.
Dell EMC highly recommends using auto-negotiation for the Management port.
● The no version of this command resets the port speed to the default value auto.
Example
OS10(conf-if-ma-1/1/1)# speed auto
Supported
Releases
10.3.0E or later
switch-port-profile
Configures a port profile on the switch. The port profile determines the available front-panel ports and breakout modes.
Syntax
switch-port-profile node/unit profile
Parameters
● node/unit — Enter switch information. For a standalone switch, enter 1/1.
● profile — Enter the name of a platform-specific profile.
Default
profile-1
308 Interfaces