Manualshelf

Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4148U-ON
691692693694695696697698699700
Table Of Contents
Command Mode EXEC
Usage
Information
● Neighbor—Displays the BGP neighbor address.
● AS—Displays the AS number of the neighbor
● MsgRcvd—Displays the number of BGP messages that the neighbor received.
● MsgSent—Displays the number of BGP messages that the neighbor sent.
● Up/Down—Displays the amount of time that the neighbor is in the Established stage. If the
neighbor has never moved into the Established stage, the word never displays. The output format
is:
1 day = 00:12:23 (hours:minutes:seconds), 1 week = 1d21h (DaysHours),
1 week + 11w2d (WeeksDays)
● State/Pfxrcd—If the neighbor is in the Established stage, this is the number of network
prefixes received. If you configured a maximum limit using the neighbor maximum-prefix
command, prfxd appears in this column. If the neighbor is not in the Established stage, the
current stage - Idle, Connect, Active, OpenSent, OpenConfirm displays. When the peer is
transitioning between states and clearing the routes received, the phrase Purging may appear in this
column. If the neighbor is disabled, the phrase Admin shut appears in this column.
The suppressed status of aggregate routes may not display in the command output.
Example
OS10# show ip bgp summary
BGP router identifier 80.1.1.1 local AS number 102
Neighbor AS MsgRcvd MsgSent Up/Down State/Pfx
80.1.1.2 800 24 23 00:09:15 5
Example for unnumbered peer:
OS10# show ip bgp summary
BGP router identifier 89.101.17.125 local AS number 100
Neighbor AS MsgRcvd
MsgSent Up/Down State/Pfx
ethernet1/1/1 200 19
19 00:15:34 0
Supported
Releases
10.2.0E or later
show ip route
Displays information about IPv4 BGP routing table entries.
Syntax
show ip route [vrf vrf-name] bgp
Parameters
● vrf vrf-name — Enter vrf and then the name of the VRF to view information that is exchanged between BGP
neighbors corresponding to that VRF
Default Not configured
Command Mode EXEC
Usage
Information
This command displays information about IPv4 BGP routing table entries.
Example
OS10# show ip route
Codes: C - connected
S - static
B - BGP, IN - internal BGP, EX - external BGP
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, * - candidate default,
+ - summary route, > - non-active route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
694 Layer 3