Reference Guide

Parameters
● node/slot — Enter 1/1 for node/slot when you configure a port group.
● port-group — Enter the port-group number (1–14). The available port-group range depends on the
switch.
Default Not configured
Command mode CONFIGURATION
Usage
information
Enter PORT-GROUP mode to:
● Configure unified ports in Fibre Channel or Ethernet mode and break out interfaces with a specified
speed.
● Break out a QSFP28-DD port into multiple interfaces with a specified speed.
To view the ports that belong to a port group, enter the show port-group command.
Example
OS10(config)# port-group 1/1/8
OS10(conf-pg-1/1/8)#
Supported
releases
10.3.1E or later
scale-profile vlan
Configures the L2 VLAN scale profile on a switch.
Syntax
scale-profile vlan
Parameters None
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
Use the VLAN scale profile when you scale the number of VLANs so that less memory is consumed.
Enable the scale profile before you configure VLANs on the switch. The scale profile globally applies L2
mode on all VLANs you create and disables L3 transmission. The no version of the command disables L2
VLAN scaling. To enable L3 routing traffic on a VLAN, use the mode L3 command.
Example
OS10(config)# scale-profile vlan
Supported
Releases
10.4.0E(X2) or later
show discovered-expanders
NOTE: This command will be supported in future releases.
Syntax
show discovered-expanders
show interface
Displays interface information.
Syntax
show interface [type]
Parameters interface type — Enter the interface type:
● phy-eth node/slot/port[:subport] — Display information about physical ports connected to
the interface.
● status — Display interface status.
● ethernet node/slot/port[:subport] — Display Ethernet interface information.
● loopback id — Display loopback IDs (0 to 16383).
106 Interfaces