Reference Guide

fibrechannel1/1/9
fibrechannel1/1/10
fibrechannel1/1/11
fibrechannel1/1/12
fibrechannel1/1/15
fibrechannel1/1/17
fibrechannel1/1/18
fibrechannel1/1/19
fibrechannel1/1/20
fibrechannel1/1/21
fibrechannel1/1/22
fibrechannel1/1/23
fibrechannel1/1/24
fibrechannel1/1/25:1
fibrechannel1/1/29:1
fibrechannel1/1/30:1
fibrechannel1/1/30:3
====================================
Supported
Releases
10.3.1E or later
vfabric
Configures a virtual fabric (vfabric). Enable the F_Port before configuring a vfabric. You can configure only one vfabric in
F_Port mode. The vfabric becomes active only when you configure the vfabric with a valid VLAN and FC map. Do not use
spanned VLAN as vfabric VLAN.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command removes the vfabric. You can remove a vfabric only when it is not
applied on any interfaces.
Example
OS10(config)# vfabric 100
Supported
Releases
10.3.1E or later
vfabric (interface)
Applies an existing vfabric to an Ethernet or FC interface.
Syntax
vfabric fabric-ID
Parameters fabric-ID — Enter the fabric ID, from 1 to 255.
Defaults Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command removes the vfabric from the interface.
Example
OS10(config)# interface fibrechannel 1/1/1
OS10(conf-if-fc1/1/1)# vfabric 100
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# vfabric 200
Fibre Channel 135