Reference Guide

Supported Releases 10.3.0E or later
log-adjacency-changes
Enables logging of syslog messages about changes in the OSPFv3 adjacency state.
Syntax
log-adjacency-changes
Parameters None
Default Disabled
Command Mode ROUTER-OSPFv3
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# log-adjacency-changes
Supported Releases 10.3.0E or later
maximum-paths
Enables forwarding of packets over multiple paths.
Syntax
maximum—paths number
Parameters number —Enter the number of paths for OSPFv3 (1 to 64).
Default Disabled
Command Mode ROUTER-OSPFv3
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# router ospfv3
OS10(config-router-ospfv3-100)# maximum-paths 1
Supported Releases 10.3.0E or later
redistribute
Redistributes information from another routing protocol or routing instance to the OSPFv3 process.
Syntax
redistribute {bgp as-number | connected | static} [route-map route-map name]
Parameters
• as-number — Enter an autonomous number to redistribute BGP routing information throughout the OSPFv3
instance (1 to 4294967295).
• route-map name — Enter the name of a congured route-map.
• connected — Enter the information from connected (active) routes on interfaces to redistribute.
• static — Enter the information from static routes on interfaces redistribute.
Defaults Not congured
Command Mode ROUTER-OSPFv3
Usage Information When an OSPFv3 redistributes, the process is not completely removed from the BGP conguration. The no
version of this command disables the redistribute conguration.
388 Layer 3