Connectivity Guide

Available
*: VLT port-channel, V: VLT status, P: Peer Operational status ^: Tracking
status
Uplink State Group : 1 Name: iscsi_group, Status: Enabled, Up
Upstream Interfaces : eth1/1/36(Up) *po30(^V:Up, P:Dwn) VLTi(Up)
Downstream Interfaces : eth1/1/4(Up) *po20(V: Up,P: Up)
Supported Releases 10.4.0E(R3) or later
uplink-state-group
Creates an uplink-state group and enables upstream link tracking.
Syntax
uplink-state-group group-id
Parameters group-id — Enter a unique ID for the uplink-state group, from 1 to 32.
Default None
Command Mode CONFIGURATION
Usage Information The no version of this command removes the uplink-state group.
Example
OS10(config)# uplink-state-group 1
Supported Releases 10.4.0E(R3) or later
upstream
Adds an interface or a range of interfaces as an upstream interface to the uplink-state group.
Syntax
upstream {interface-type | interface-range [ track-vlt-status ] | VLTi}
Parameters
• interface-type — Enter the interface type as Ethernet or port-channel.
• interface-range — Enter the range of interfaces.
• VLTi—Congures VLTi Link as member of uplink state group.
• track-vlt-status—(Optional) Tracks the VLT status for the upstream member. This option applies only
for port-channel interfaces.
Default
When you add an upstream member without the track-vlt-status option, the operational status is tracked
by default.
Command Mode UPLINK-STATE-GROUP
Usage Information You cannot assign an interface that is already a member of an uplink-state group to another group. The no version
of this command removes the interface from the uplink-state group.
Example
OS10(config)# uplink-state-group 1
OS10(conf-uplink-state-group-1)# upstream ethernet 1/1/45-1/1/48
OS10(conf-uplink-state-group-1)# upstream VLTi
OS10(conf-uplink-state-group-1)# upstream port-channel 10 track-vlt-status
Uplink Failure Detection 869