Users Guide

description
Configures an ACL description.
Syntax
description text
Parameters text — Enter the description text string. A maximum of 80 characters.
Default Disabled
Command Modes IPV4-ACL, IPV6-ACL, MAC-ACL
Usage
Information
● To use special characters as a part of the description string, enclose the string in double quotes.
● To use comma as a part of the description string add double back slash before the comma.
● The no version of this command deletes the ACL description.
Example
OS10(conf-ipv4-acl)# description ipacltest
Supported
Releases
10.2.0E or later
ip access-group
Configures an IPv4 access group.
Syntax
ip access-group access-list-name {in | out}
Parameters
● access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
● in — Apply the ACL to incoming traffic.
● out — Apply the ACL to outgoing traffic.
Default Not configured
Command Mode
INTERFACE
CONTROL-PLANE
Usage
Information
Use this command in the CONTROL-PLANE mode to apply a control-plane ACL. Control-plane ACLs are
only applied on the ingress traffic. By default, the control-plane ACL is applied to the front-panel ports as
well as the management port.The no version of this command deletes the IPv4 ACL configuration.
Example
OS10(conf-if-eth1/1/8)# ip access-group testgroup in
Example
(Control-plane
ACL)
OS10# configure terminal
OS10(config)# control-plane
OS10(config-control-plane)# ip access-group aaa-cp-acl in
Supported
Releases
10.2.0E or later; 10.4.1 or later (control-plane ACL)
ip access-list
Creates an IP access list to filter based on an IP address.
Syntax
ip access-list access-list-name
Parameters access-list-name — Enter the name of an IPv4 access list. A maximum of 140 characters.
Default Not configured
Command Mode CONFIGURATION
Access Control Lists 1263