Users Guide

Parameters
● map-name — Enter the name of the route-map. A maximum of 140 characters.
● sequence-number — (Optional) Enter the number to identify the route-map for editing and
sequencing number from 1 to 65535. The default is 10.
● permit — (Optional) Set the route-map default as permit.
● deny — (Optional) Set the route default as deny.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
NOTE: Exercise caution when you delete route-maps — if you do not enter a sequence number, all
route-maps with the same map-name are deleted.
The no version of this command removes a route-map.
Example
OS10(config)# route-map route1 permit 100
OS10(config-route-map)#
Supported
Releases
10.2.0E or later
set comm-list add
Add communities in the specified list to the COMMUNITY attribute in a matching inbound or outbound BGP route.
Syntax
set comm-list {community-list-name} add
Parameters community-list-name — Enter the name of an established community list. A maximum of 140
characters.
Defaults None
Command Mode ROUTE-MAP
Usage
Information
In a route map, use this set command to add a list of communities that pass a permit statement to the
COMMUNITY attribute of a BGP route sent or received from a BGP peer. Use the set comm-list
delete command to delete a community list from a matching route.
Example
OS10(config)# route-map bgp
OS10(conf-route-map)# set comm-list comlist1 add
Supported
Releases
10.4.0E(R1) or later
set comm-list delete
Remove communities in the specified list from the COMMUNITY attribute in a matching inbound or outbound BGP route.
Syntax
set comm-list {community-list-name} delete
Parameters community-list-name — Enter the name of an established community list. A maximum of 140
characters.
Defaults None‘
Command Mode ROUTE-MAP
Usage
Information
Configure the community list you use in the set comm-list delete command so that each filter
contains only one community. For example, the filter deny 100:12 is acceptable, but the filter deny
120:13 140:33 results in an error. If you configure the set comm-list delete command and the
set community command in the same route map sequence, the deletion set comm-list delete
command processes before the insertion set community command . To add communities in a
community list to the COMMUNITY attribute in a BGP route, use the set comm-list add command.
1308 Access Control Lists