Users Guide

Parameters temperature | voltage | rx-power | tx-power | bias — Enter the keyword to enable
DOM traps for the specified category.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command disables the DOM traps.
Example
OS10# configure terminal
OS10(config)# snmp-server enable traps dom temperature
OS10# configure terminal
OS10(config)# no snmp-server enable traps dom temperature
Supported
Releases
10.4.3.0 or later
feature auto-breakout
Enables front-panel Ethernet ports to automatically detect SFP media and autoconfigure breakout interfaces.
Syntax
feature auto-breakout
Parameters None
Default Not configured
Command mode CONFIGURATION
Usage
information
After you enter the feature auto-breakout command and plug a supported breakout cable in a
QSFP+ or QSFP28 port, the port autoconfigures breakout interfaces for media type and speed.
Use the interface breakout command to manually configure breakout interfaces. The media type
plugged into a port is no longer automatically learned. The no version of this command disables the auto-
breakout feature.
Example
OS10(config)# feature auto-breakout
Supported
releases
10.4.0E(R1) or later
fec
Configures Forward Error Correction on 25G, 50G, and 100G interfaces.
Syntax
fec {CL74-FC | CL91-RS | CL108-RS | off}
Parameters
● CL74-FC — Supports 25G and 50G
● CL91-RS — Supports 100G
● CL108-RS — Supports 25G and 50G
● off — Disables FEC
Defaults
NOTE: Default FEC settings are determined by the inserted media type.
● For 25G and 50G interfaces: off, CL108-RS, or auto-negotiate
● For 100G interfaces: off, CL91-RS, or auto-negotiate
Command Mode CONFIGURATION
Usage
Information
The no version of this command resets the value to the default.
Interfaces 291