API Guide
Supported
Releases
10.2.0E or later; 10.4.1 or later (control-plane ACL)
mac access-list
Creates a MAC access list to filter based on a MAC address.
Syntax
mac access-list access-list-name
Parameters access-list-name — Enter the name of a MAC access list. A maximum of 140 characters.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
None
Example
OS10(config)# mac access-list maclist
Supported
Releases
10.2.0E or later
permit
Configures a filter to allow packets with a specific IPv4 address.
Syntax
permit [protocol-number | icmp | ip | tcp | udp] [A.B.C.D | A.B.C.D/x | any
| host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture |
count | dscp value | fragment | log]
Parameters
● protocol-number — (Optional) Enter the protocol number identified in the IP header, from 0 to
255.
● icmp — (Optional) Enter the ICMP address to permit.
● ip — (Optional) Enter the IPv4 address to permit.
● tcp — (Optional) Enter the TCP address to permit.
● udp — (Optional) Enter the UDP address to permit.
● A.B.C.D — Enter the IPv4 address in dotted decimal format.
● A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
● any — (Optional) Enter the keyword any to specify any source or destination IP address.
● host ip-address — (Optional) Enter the IPv4 address to use a host address only.
● capture — (Optional) Capture packets the filter processes.
● count — (Optional) Count packets the filter processes.
● byte — (Optional) Count bytes the filter processes.
● dscp value — (Optional) Permit a packet based on the DSCP values, from 0 to 63.
● fragment — (Optional) Use ACLs to control packet fragments.
● log — (Optional) Enables ACL logging. Information about packets that match an ACL rule are logged.
Default Not configured
Command Mode IPV4-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes
increment. The no version of this command removes the filter.
Example
OS10(config)# ip access-list testflow
OS10(conf-ipv4-acl)# permit udp any any capture session 1
Supported
Releases
10.2.0E or later
Access Control Lists 1145