API Guide
Example
OS10(config)# ipv6 access-list ipv6test
OS10(conf-ipv6-acl)# seq 5 deny ipv6 any any capture session 1 count log
Supported
Releases
10.2.0E or later
seq deny (MAC)
Assigns a sequence number to a deny filter in a MAC access list while creating the filter.
Syntax
seq sequence-number deny {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any}
{nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture |
cos | count [byte] | vlan]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
● nn:nn:nn:nn:nn:nn — Enter the source MAC address.
● 00:00:00:00:00:00 — (Optional) Enter which bits in the MAC address must match. If you do not
enter a mask, a mask of 00:00:00:00:00:00 applies.
● any — (Optional) Set all routes which are subject to the filter:
○ protocol-number — Protocol number identified in the MAC header, from 600 to ffff.
○ capture — (Optional) Capture packets the filter processes.
○ cos — (Optional) CoS value, from 0 to 7.
○ count — (Optional) Count packets the filter processes.
○ byte — (Optional) Count bytes the filter processes.
○ vlan — (Optional) VLAN number, from 1 to 4093.
Default Not configured
Command Mode CONFIG-MAC-ACL
Usage
Information
OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes
increment. The no version of this command removes the filter, or use the no seq sequence-number
command if you know the filter’s sequence number.
Example
OS10(config)# mac access-list macacl
OS10(conf-mac-acl)# seq 10 deny 00:00:00:00:11:11 00:00:11:11:11:11 any
cos 7
OS10(conf-mac-acl)# seq 20 deny 00:00:00:00:11:11 00:00:11:11:11:11 any
vlan 2
Supported
Releases
10.2.0E or later
seq deny icmp
Assigns a filter to deny ICMP messages while creating the filter.
Syntax
seq sequence-number deny icmp [A.B.C.D | A.B.C.D/x | any | host ip-address]
[A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count | dscp value
| fragment | log]
Parameters
● sequence-number — Enter the sequence number to identify the route-map for editing and
sequencing number, from 1 to 16777214.
● A.B.C.D — Enter the IPv4 address in dotted decimal format.
● A.B.C.D/x — Enter the number of bits that must match the dotted decimal address.
● any — (Optional) Enter the keyword any to specify any source or destination IP address.
● host ip-address — (Optional) Enter the IPv4 address to use a host IP address only.
1154 Access Control Lists