API Guide

4. Create a L3 Routed uplink by providing the name and description, and click NEXT.
5. Associate an interface from the spine or leaf switch with the L3 Routed uplink.
● Spine — Select a spine switch and an interface from the spine to associate with the uplink.
● Leaf — Select a leaf switch from the rack, and an interface from the leaf switch to associate with the uplink.
NOTE: You can select only one interface from the spine or leaf switch for L3 Routed uplink.
6. Create a L3 Routed network to associate by providing a name, description, interface IP address, and prefix length.
7. Define a routing policy to associate with the uplink based on the external network connectivity setup.
● Static Route — A route policy template that contains a network prefix and the next hop IP address.
● eBGP — A routing policy template that contains BGP peer IP address and the remote AS number.
NOTE: You cannot associate a L3 Routed network with more than one uplink or server profile.
You can view and delete a routing profile from the Routing Profiles tab.
Breakout Switch Ports wizard
Breakout the speed of the physical Ethernet ports or port-group of the leaf switches, to connect to the external device or jump
host.
This wizard allows you to breakout Ethernet ports. To do so:
1. Launch the Breakout Switch Ports wizard.
2. Select the rack from the list.
3. Select the leaf switch in the rack.
4. Select a port-group or a physical Ethernet port of the leaf switch to breakout.
5. Select the appropriate breakout option from the list, and click OK.
NOTE: Breakout autoconfiguration is supported in spine.
Configure Jump Host wizard
A jump host is a designated port to which an external device such as laptop can be connected. You can configure only one port
in a leaf switch as a jump port for the external device to connect to L3 fabric. You can select any available port that is not part
of an uplink and ICL, and port connected to a server in SmartFabric deployment.
This wizard allows you to configure the jump host. To do so:
1. Launch the Configure Jump Host wizard.
2. Assign a user-friendly name and description for the jump host.
3. Select a leaf switch from the rack.
4. Select an interface of the leaf switch as the jump host.
5. Associate an untagged network with the jump host, and click OK.
You can view the configured jump host in SFS GUI Uplinks tab. You can also delete any created jump host from this tab. Select
the jump host from the list, and click DELETE.
Update Network Configuration wizard
You can edit the network configuration that is applied on the uplink and server profiles in the fabric after completing the initial
fabric setup using the Update Network Configuration wizard. To do so:
1. Launch Update Network Configuration wizard.
2. Select the VLAN or virtual network to edit.
3. Update the relevant details for the interface, gateway, and DHCP helper IP addresses, and click OK.
SmartFabric Services
131