API Guide
logging monitor
Set the minimum severity level for logging to the terminal lines.
Syntax
logging monitor severity severity-level
Parameters severity-level — Set the minimum logging severity level:
● log-emerg — Set the system as unusable.
● log-alert — Set to immediate action is needed.
● log-crit — Set to critical conditions.
● log-err — Set to error conditions.
● log-warning — Set to warning conditions.
● log-notice — Set to normal but significant conditions, the default.
● log-info — Set to informational messages.
● log-debug — Set to debug messages.
Default Log-notice
Command Mode CONFIGURATION
Usage
Information
To reset the monitor severity to the default level, use the no logging monitor severity
command. The default severity level is log-notice.
Supported on the MX9116n and MX5108n switches in Full Switch mode starting in release 10.4.0E(R3S).
Also supported in SmartFabric mode starting in release 10.5.0.1.
Example
OS10(config)# logging monitor severity log-info
Supported
Releases
10.2.0E or later
logging security-profile
Creates a TLS security profile for system logging.
Syntax
logging security-profile profile-name
Parameters profile-name — Enter the name of the Syslog over TLS security profile created with the crypto
security-profile profile-name command; a maximum of 32 characters.
Default Not configured
Command mode CONFIGURATION
Usage
information
Use this command to specify the configured crypto security profile to use to send system messages to a
remote server over TLS. TLS requires an X.509v3 certificate-key pair installed on the switch.
Example
OS10(config)# logging security-profile prof1
Supported
releases
10.5.0 or later
logging server
Configures a remote syslog server.
Syntax
logging server {ipv4–address | ipv6–address} [tcp | udp | tls] [port-
number] [severity severity-level] [vrf {management | vrf-name]
Parameters
● ipv4–address | ipv6–address — (Optional) Enter the IPv4 or IPv6 address of the logging
server.
Troubleshoot Dell EMC SmartFabric OS10 1449