API Guide

To log in to OS10 and access the command-line interface, enter su — admin at the Linux shell prompt, then admin as the
password.
linuxadmin@OS10:~$ su - admin
Password: admin
OS10#
Frequently asked questions
This section contains answers to frequently asked questions for ONIE-enabled devices.
● Installation contains information about how to enter ONIE: Install mode after a reboot, find information about your specific
switch, how to log into the OS10 shell, and so on.
● Hardware contains information about how to view default console settings, how to view hardware alarms and events, how to
view LED status, and so on.
● Configuration contains information about how to enter CONFIGURATION mode, how to modify the candidate configuration,
and so on.
● Security contains information about how to add users, troubleshoot RADIUS, how to view current DHCP information, and so
on.
● Layer 2 contains information about how to configure routing information including 802.1X, LACP, LLDP, MAC, and so on.
● Layer 3 contains information about how to troubleshoot BCP, ECMP, OSPF, and so on.
● System management contains information about how to view current interface configuration information, how to view a list
of all system devices, how to view the software version, and so on.
● Quality of service contains information about quality of service including classification and marking, congestion management,
policing and shaping, and so on.
● Monitoring contains information about how to view alarms, events, logs, and so on.
Installation
How do I configure a default management route?
Although the default management route was configured during installation, you can use the route add default gw
command from the Linux shell to configure the default management IP address for routing. SupportAssist requires the default
management route is configured to work properly, as well as DNS configured and a route to a proxy server.
How do I log into the OS10 shell as the system administration?
Use linuxadmin as the username and password to enter OS10 at root level.
Where can I find additional installation information for my specific device?
See the Setup Guide shipped with your device or the platform-specific Installation Guide on the Dell EMC Support page at
dell.com/support.
Hardware
What are the default console settings for ON-Series devices?
● Set the data rate to 115200 baud
● Set the data format to 8 bits, stop bits to 1, and no parity
● Set flow control to none
How do I view the hardware inventory?
Use the show inventory command to view complete system inventory.
How do I view the process-related information?
Use the show processes node-id node-id-number [pid process-id] command to view the process CPU
utilization information.
Troubleshoot Dell EMC SmartFabric OS10
1453