API Guide
4. Apply the vFabric configuration on the interface that connects to CNA 1.
OS10(config)# interface ethernet 1/1/50
OS10(conf‐if‐eth1/1/50)# vfabric 2
5. Enable DCBX globally.
OS10(config)# dcbx enable
6. Create a class map and policy map.
OS10(config)# class‐map type network‐qos cmap1
OS10(config‐cmap‐nqos)# match qos‐group 3
OS10(config)# policy‐map type network‐qos pmap1
OS10(config‐pmap‐network‐qos)# class cmap1
OS10(config‐pmap‐c‐nqos)# pause
OS10(config‐pmap‐c‐nqos)# pfc‐cos 3
7. Disable LLFC on the interface that connects to CNA 1.
OS10(config)# interface ethernet 1/1/50
OS10(conf‐if‐eth1/1/50)# no flowcontrol receive
8. Enable the PFC mode on the interface that connects to CNA 1.
OS10(config)# interface ethernet 1/1/50
OS10(conf‐if‐eth1/1/50)# priority‐flow‐control mode on
9. Apply the service policy on the interface that connects to CNA 1.
OS10(config)# interface ethernet 1/1/50
OS10(conf‐if‐eth1/1/50)# service‐policy input type network‐qos pmap1
10. Configure the interface that connects to NPG2.
OS10(config)# interface fibrechannel 1/1/5
OS10(config-if‐fc1/1/5)# vfabric 2
NPG2 switch configuration
1. Enable the NPG feature.
OS10(config)# feature fc npg
2. Configure vFabric.
OS10(config)# vfabric 2
OS10(conf‐vfabric‐2)# vlan 1000
OS10(conf‐vfabric‐2)# name fcoe_fabric
OS10(conf‐vfabric‐2)# fcoe fcmap 0efc02
3. Apply the vFabric configuration on the interface that connects to the NPG1 switch. Change port mode to F_Port.
OS10(config)# interface fibrechannel 1/1/5
OS10(conf‐if‐fc1/1/21)# vfabric 2
OS10(conf‐if‐fc1/1/21)# fc port‐mode f
4. Apply the vFabric configuration on the interface that connect to CNA 2.
OS10(config)# interface ethernet 1/1/1
OS10(conf‐if‐eth1/1/1)# vfabric 2
5. Enable DCBX globally.
OS10(config)# dcbx enable
Fibre Channel
365