API Guide

Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd max-ra-interval 300
Supported
Releases
10.4.0E(R1) or later
ipv6 nd mtu
Sets the maximum transmission unit (MTU) used on a local link in RA messages.
Syntax
ipv6 nd mtu number
Parameters
● mtu number — Enter the MTU size in bytes, from 1280 to 65535.
Defaults 1500 bytes
Command Mode INTERFACE
Usage
Information
The no version of this command restores the default MTU value advertised in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd mtu 2500
Supported
Releases
10.4.0E(R1) or later
ipv6 nd other-config-flag
Sends RA messages that tell hosts to use stateful autoconfiguration to obtain nonaddress-related information.
Syntax
ipv6 nd other-config-flag
Parameters None
Defaults Not configured
Command Mode INTERFACE
Usage
Information
The no version of this command disables the other-config-flag option in RA messages.
Example
OS10(config)# interface ethernet 1/2/3
OS10(conf-if-eth1/2/3)# ipv6 nd other-config-flag
Supported
Releases
10.4.0E(R1) or later
ipv6 nd prefix
Configures the IPv6 prefixes that are included in messages to neighboring IPv6 routers.
Syntax
ipv6 nd prefix {ipv6-prefix | default} [no-advertise] [no autoconfig] [no-
rtr-address] [off-link] [lifetime {valid-lifetime seconds | infinite}
{preferred-lifetime seconds | infinite}]
Parameters
● ipv6-prefix — Enter an IPv6 prefix in x:x::y/mask format to include the prefix in RA mesages.
Include prefixes that are not already in the subnets on the interface.
● default — Configure the prefix parameters advertised in all subnets configured on the interface.
● no-advertise — (Optional) Do not advertise the specified prefix. By default, all prefixes in
configured subnets advertise.
Layer 3 679