Specifications

DMA clock gating: disabled
TBI mode: disabled
Link speed: 1000Mb/s
Bus type: PCI Express
...
root@dellemc-diag-os:/etc/dn/diag# phytool --lb-test=100
TEST PASSED
NOTE: The loopback test and set-intf will terminate the ethernet driver. You need to
reboot to restart the driver cleanly.
[1]+ Terminated setsid /bin/kni -c 0x3 -n 2 -- -p 1 --config="(0,0,1)" >> /dev/null
root@dellemc-diag-os:~# phytool --set-intf --speed=1000
[2]+ Done dhclient -q eth0
root@dellemc-diag-os:~# ........................done
Port 0 Link Up - speed 1000 Mbps - full-duplex
root@dellemc-diag-os:~# root@dellemc-diag-os:~# phytool --show-intf
Settings for eth0:
Supported ports: [ TP ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: Symmetric
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: No
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: Twisted Pair
PHYAD: 3
Transceiver: internal
Auto-negotiation: on
MDI-X: off (auto)
Supports Wake-on: pumbg
Wake-on: g
Current message level: 0x00000007 (7)
drv probe link
Link detected: yes
pltool
To test functionality of the CPLD and FPGA devices on the boards during startup, use the pltool.
The pltool also checks for the correct firmware loads. The tool uses the CLI to list the devices and their registers, and allows
you to read and write registers in the device. The read functionality prints the details to the bit level and also any bit groupings
and their meanings. The tool uses the SDI interface to get a list of devices and registers in the system, and then uses SDI to
access the devices.
Tests
The pltool tests specified registers that SDI identifies in the testable bits of the register. The tool reads the register using SDI
interfaces and compares the testable bits from those bits the SDI database provides. If a mismatch occurs, an error is displayed.
CLI options
root@dellemc-diag-os:~# pltool
DellEmc Diag - Programable Logic Tool
version x.x, x.xx.x.x-x
build, yyyy/mm/dd,
Dell EMC DAIG-OS tools
63